Fuel Line Coolant Hose Blockage Solution

What are the solutions to fuel line cooler hose blockage:

1. If there is air in the pipeline, after stepping on the brake, the air in the oil circuit will be compressed, making the brake soft, increasing the invalid stroke, and significantly reducing the braking force, which is very dangerous;

2. Therefore, when changing the brake fluid, most mechanics will use more than two bottles of brake fluid, mainly to exhaust the pipeline;

3. When the brake is stepped on, the brake master cylinder pushes the brake oil in the liquid storage pot to the sub-pumps of each wheel. When the system is in trouble, a vacuum will be formed in the pipeline when the brake is stepped on, causing the brake to be soft. The vacuum also forms air.

The consequences of fuel line coolant hose clogging: If it is serious, it will affect the start, because it is compression ignition, if the air-fuel ratio is not well controlled during fuel injection. But generally speaking, it can be started, but black smoke. When the gasoline pump is working, if the oil return pipe is blocked, the oil pressure in the oil pipe between the gasoline pump and the carburetor will increase accordingly. Therefore, in order to balance the pressure of the carburetor inlet needle valve.

Prevent dirt from clogging: Do not remove the filter screen on the fuel tank cover. The oil drain plug at the bottom of the fuel tank is generally magnetic, which can absorb iron dirt in the fuel tank. Do not replace it casually, but clean it regularly; do not use unclean For oil products, the filters in the pipeline should be cleaned regularly; anti-freezing and clogging: use oil products according to the season to prevent freezing and pipe folding and clogging. Regularly straighten the oil pipes to prevent them from being folded or squeezed to cause clogging.

The above is the relevant content about the solution to the blockage of the fuel line cooler hose connector. I hope this article will be helpful to you.